| Issue | Title | |
| Vol 4, No 2 (2018) | An Investigative Review of Cryogenic Systems Based on Cryogenic Machining and Treatment Processes for Low-Temperature Applications | Abstract |
| Daiveek L, Abhay A D, S.A. Mohan Krishna, Dr. G V Naveen Prakash, Dr. K S Ravi, Dr. K B Vinay | ||
| Vol 4, No 2 (2018) | An Investigative Review on the Use of Gifford–McMahon Cryocooler Based on Performance Parameters for Low-Temperature Applications | Abstract |
| V H Shravana Kumar, Shreenivas Sourab, M Shashank, S. A. Mohan Krishna, Dr G V Naveen Prakash, Dr. K S Ravi, Dr. K B Vinay | ||
| Vol 1, No 2 (2016) | Analysis of Comparison of Fluid Jet Impingement Heat Transfer on Flat Plate Using CFD | Abstract |
| K.Siva Satya Mohan, S. K. Bhatti | ||
| Vol 3, No 1 (2017) | Blend Stability and Engine Performance Studies of Ethanol-Biodiesel-Diesel Blends | Abstract |
| arun kumar | ||
| Vol 1, No 1 (2016) | Clean Energy Cng For Indian Telecom Towers | Abstract |
| SHIVAJI BHANDARKAR | ||
| Vol 3, No 1 (2017) | Cyclic Voltammetric Study of Ru Incorporated Copper Oxide Synthesized by Electrodeposition via Nonaqueous Route | Abstract |
| B. J. Lokhande, T. S. Ghadge | ||
| Vol 1, No 1 (2016) | Design and thermal analysis of shell and tube type condenser | Abstract |
| Poonam Diwan | ||
| Vol 1, No 2 (2016) | Evaluation and Prediction of Flow Accelerated Corrosion and Wall Thinning in Pipe Bends | Abstract |
| C. P. Karthikeyan, V Umasankar, T. R. Vijayaram | ||
| Vol 3, No 1 (2017) | Experimental Investigation of Optimum Injection Pressure for Ethanol-Biodiesel-Diesel Blend | Abstract |
| arun kumar | ||
| Vol 1, No 2 (2016) | Experimental Study of Biomass Gasification in a Downdraft Gasifier Using Different Feedstocks | Abstract |
| Henok Mekonnen Mossissa | ||
| Vol 4, No 2 (2018) | Flow Simulation of Nano-particles in a Planar Spiral Coil | Abstract |
| Hamidreza Ghasemi Bahraseman, Morteza Mohssenzadeh, Bryan Doney, Ricardo Gonzalez, Peter Konopasky, Kevin Wong, Alexandria Santrach, Marlon Quintanilla, JPaul Koutoulas, Joel Maguire | ||
| Vol 1, No 2 (2016) | Hazard Analysis For Pulverising Mill | Abstract |
| Siva kumar C., S. Bhaskar | ||
| Vol 1, No 1 (2016) | Hazard Identification and Risk Assessment for Pulverizing Mill | Abstract |
| Siva kumar C., S. Bhaskar | ||
| Vol 1, No 2 (2016) | Highlights on the TPS Used For Spacecraft During Atmospheric Reentry | Abstract |
| Priyanka Garg | ||
| Vol 4, No 2 (2018) | Influences of Heat Exchanger Aspect Ratio and Carbon Additives on PCM-Mixture Heat Storage | Abstract |
| Hamidreza Ghasemi Bahraseman, Morteza Mohssenzadeh, Hayden Reilly, Siqi Tan, Anthony Olguin, David Moreno, J. Paul Koutoulas, Brandon Mori | ||
| Vol 1, No 2 (2016) | Life Cycle Assessment of 100 kWp Grid Connected Rooftop Solar Photovoltaic (SPV) System Installed at Poornima University, Jaipur | Abstract |
| Pratish Rawat | ||
| Vol 1, No 1 (2016) | Microwave Assisted Extraction of Pongamia Pinnata Oil with Pulsating Heating | Abstract |
| Chandra Kumar Renuka, M. M. Benal, B. Durga Prasad | ||
| Vol 4, No 1 (2018) | Modeling and Thermodynamic Analysis of Gas Turbine Cycle with Regenerator | Abstract |
| Kiumars Khani Aminjan | ||
| Vol 3, No 2 (2017) | Modeling of Double-Pass Flat Plate Solar Air Heater with Porous Media | Abstract |
| Rahul Mistry, Akshada Mule, Kalpesh Kurade, Sonal Padule | ||
| Vol 3, No 1 (2017) | Numerical simulation of thermal and airflow analysis in a flat unglazed transpired solar collector (UTC) | Abstract |
| Sarat Maharana, Sajna Panigrahi | ||
| Vol 1, No 1 (2016) | Numerical Study of One Dimensional Free Convection Heat and Mass Transfer of Fresh and Salt Water Flow on an Infinite Inclined Plate with Hall Current and Constant Heat Flux in Presence of Magnetic Field | Abstract |
| Mohammad Shah Alam, Ashutose Saha | ||
| Vol 4, No 2 (2018) | On the Effects of Inclination Angle and Temperature-Dependent Internal Heat Generation on the Thermal Performance of Porous Fin Heat Sink | Abstract |
| Gbeminiyi Musibau Sobamowo, George A. Oguntala | ||
| Vol 3, No 1 (2017) | Optimization of Esterification and Transesterification of Karanja Oil for Production of Biodiesel | Abstract |
| Ashlesa Mohapatra, R. Saiteja | ||
| Vol 1, No 1 (2016) | Optimum temperature on atomization of starch based vicous polymer | Abstract |
| Muhammad Yasin Naz, Shaharin Anwar Sulaiman | ||
| Vol 3, No 2 (2017) | Performance Enhancement of R-134a Refrigeration Cycle by Using Solar Peltier Subcooler | Abstract |
| M. Ravikiran, K. Dilip Kumar | ||
| 1 - 25 of 37 Items | 1 2 > >> | |