Design and Fabrication of Canal Turbine with the Use of different Design Parts

Arish Chauhan; Sanjay Kumar Yadav; Rishabh Kumar Sharma; Aman Singh; Ankit Nautiyal

doi:10.37628/jmdm.v3i2.585

Authors

Arish Chauhan Department of Mechanical Engineering, G.L. Bajaj Institute of Technology and Management, Greater Noida, Uttar Pradesh,
Sanjay Kumar Yadav Department of Mechanical Engineering, G.L. Bajaj Institute of Technology and Management, Greater Noida, Uttar Pradesh,
Rishabh Kumar Sharma Department of Mechanical Engineering, G.L. Bajaj Institute of Technology and Management, Greater Noida, Uttar Pradesh,
Aman Singh Department of Mechanical Engineering, G.L. Bajaj Institute of Technology and Management, Greater Noida, Uttar Pradesh,
Ankit Nautiyal Department of Mechanical Engineering, G.L. Bajaj Institute of Technology and Management, Greater Noida, Uttar Pradesh,

DOI:

https://doi.org/10.37628/jmdm.v3i2.585

Abstract

Government subsidy is increasing the focus on renewable energy, with in which hydrokinetic energy has the advantage of being both efficient and predictable. There is a great variation in the concept which are being developed and no industry standard approach has yet changed. This paper discusses about the design and fabrication of canal turbine under which designed parts like screw driver, weighing scale, hand saw, hammer, file, discussed. Aim of this paper is to set out to establish how the industry should approach the reduction of cost energy by investigation of option for flexible and solid moorings for hydrokinetic turbines as an option to reduce costs and improve performance.