Design and Analysis of Fatigue Failure of Ball Joint and Improve Ball Joint Design

Authors

  • Raskar N. Student, Department of Mechanical Engineering, Alard College of Engineering and Management, Pune, Maharashtra, India
  • Yerande G. Student, Department of Mechanical Engineering, Alard College of Engineering and Management, Pune, Maharashtra, India
  • Padwal S. Student, Department of Mechanical Engineering, Alard College of Engineering and Management, Pune, Maharashtra, India
  • Ganmote Y. Student, Department of Mechanical Engineering, Alard College of Engineering and Management, Pune, Maharashtra, India
  • Raut S. Assistant Professor, Department of Mechanical Engineering, Alard College of Engineering and Management, Pune, Maharashtra, India

DOI:

https://doi.org/10.37628/ijpe.v6i2.1143

Keywords:

Ball joint, fatigue analysis, stress analysis, design improvement, design calculation

Abstract

This study is about of the analysis the failure of ball joint and make the ball joint stronger by changing the neck diameter of ball joint. As the ball joint is very important part in the automobile vehicle, because of its failure the major problem can be generated. Ball joint in the automobile can fail without giving any intimation or sign. For the safety and avoid the failure of ball joint we need to design ball joint which can absorb the higher stress. We get reference of the standard ball joint used in automobile and then we test that ball joint take experiments on that, after the result observation we modified the design which can improve the stress capacity and the safety of the ball joint

References

Shinde J, Kadam S. Design of suspension ball joint using FEA and

experimental method. Int Res J Eng Technol. 2016;3(07):1853–8.

Sin BS, Lee KH. Process design of a ball joint, considering caulking and pull-out strength. The Scientific World Journal. 2014.

Ossa EA, Palacio CC, Paniagua MA. Failure analysis of a car suspension system ball joint. Engineering Failure Analysis. 2011;5(18):1388–94.

Uguz A, Oka SH. Modeling the effects of mechanical loads: Finite element modeling of ball joints under dynamic loading. Materials Testing. 2004;46(10):506–12.

Jang BH, Lee KH. Analysis and design of a ball joint, considering manufacturing process. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science. 2014;228(1):146–51.

Downloads

Published

2021-02-05

Issue

Vol. 6 No. 2 (2020)

Section

Articles