Open Access Open Access  Restricted Access Subscription or Fee Access

Lip Shape Behaviour of Sheet Metal in Hole Flanging Process

Pankaj Shrivastava

Abstract


In this paper, the lip shape behaviour of sheet metal in hole-flanging process is studied. In this study, a numerical simulation for elasto-plastic analysis of hole-flanging process is done. The lip shape behaviour on hole-flanging process is studied under different geometrical conditions such as centre hole diameter and different punch profile radii. The results of simulations are validated with a few published experimental results.

Full Text:

PDF

References


Thipprakmas S, Phanitwong W. Finite element analysis of flange-forming direction in the hole flanging process. Int J Adv Manuf Technol. 2012; 61(5–8): 609–662p.

Kacema A, Krichena A, Manachb P-Y. Occurrence and effect of ironing in the hole-flanging process. J Mater Proc Technol. 2001; 211: 1606–1613p.

Cui Z, Gao L. Studies on hole-flanging process using multistage incremental forming. CIRP J Manuf Sci Technol. 2010; 2: 124–128p.

Stachowicz F. Estimation of hole-flange ability for deep drawing steel sheets. Arch Civil Mech Eng. 2008; 8(2): 167–172p.

Li C-L, Huang Y-M, Tsai Y-W. The analysis of forming limit in re-penetration process of the hole-flanging of sheet metal. J Mater Proc Technol. 2008; 201: 256–260p.

Thipprakmas S, Jin M, Murakawa M. Study on flanged shapes in fine-blanked-hole flanging process (FB-hole flanging process) using finite element method (FEM). J Mater Proc Technol. 2007; 192–193: 128–133p.

Chen T-C. An analysis of forming limit in the elliptic hole-flanging process of sheet metal. J Mater Proc Technol. 2007; 192–193: 373–380p.

Yuung-Ming H. Hole flanging with ironing process of two-ply thick sheet metal. Trans Nonferrous Met Soc China. 2007; 17: 221–227p.

Feng X, Zhongqin L, Shuhui L, Weili S. Study on the influences of geometrical parameters on the formability of stretch curved flanging by numerical simulation. J Mater Proc Technol. 2004; 145(1): 93–98p.

Hyun DI, Oak SM, Kang SS, Moon YH. Estimation of hole flangeability for high strength steel plates. J Mater Proc Technol. 2002; 130–131: 9–13p.

Huang Y-M, Chien K-H. Influence of the punch profile on the limitation of formability in the hole-flanging process. J Mater Proc Technol. 2001; 113(1–3): 720–724p.

Huang Y-M, Chien K-H.. The formability limitation of hole flanging process. J Mater Proc Technol. 2001; 117: 43–51p.


Refbacks

  • There are currently no refbacks.